Zippy / Emacs DP1H-6400F1U 400W DC Power Supply

Specifications

Dimension:

225x100x40.5(mm)
8.85x3.94x1.59(inch)

Voltage: DC -36V~-72V
Input current: 12.0/17.0A(RMS) for -48VDC
Inrush current:less than 10A

Output Voltage	Output Current Min.	Output Current Max.	Regulation Load	Regulation Line	Output Ripple & Noise Max.[P-P]
5V	1.0	35	� 5%	� 50mV	50mV
12V	1.0	28	� 5%	� 50mV	120mV
-5V	0.1	0.5	� 10%	� 50mV	120mV
-12V	0.1	0.5	� 5%	� 50mV	150mV
3.3V	1.0	20	� 5%	� 50mV	50mV
+5VSB	0.1	2.0	� 5%	� 50mV	50mV

‧TEMPERATURE RANGE: OPERATING: -10℃---40℃(-36V~-72VDC INPUT)
-10℃---50℃(-40V~-72VDC INPUT)
STORAGE: -20℃---80℃
‧HUMIDITY:OPERATING:20%-95%, NON-OPERATING:10%-95%
‧REMARKS:85% IS NORMAL CONDITION AND 95% IS WITH SPECIAL COATING PROCESS
‧HOLD UP TIME: 1.6ms MINIMUM AT FULL LOAD & NORMAL INPUT VOLTAGE
‧DIELECTRIC WITHSTAND: INPUT/OUTPUT 1500 VAC FOR 1 SECOND
INPUT TO FRAME GROUND 1500 VAC FOR 1 SECOND
‧EFFICIENCY: 65% TYPICAL AT -48VDC FULL LOADING
‧POWER GOOD SIGNAL: ON DELAY 100ms TO 500ms, OFF DELAY 1ms
‧OVER POWER PROTECTION: 110%~150%
‧OVER VOLTAGE PROTECTION: +5V→5.5V~6.5V, 3.3V→3.9V~5.0V, +12V→13.0V~15.0V
‧SHORT CIRCUIT PROTECION: +5V, -5V, +12V, -12V, +3.3V, +5VSB
‧EMI NOISE FILTER: FCC CLASS A, CISPR22 CLASS A
‧SAFETY: UL 1950, CSA 22.2 NO/950, TUV IEC 950
‧REMOTE ON/OFF CONTROL
THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE/ENABLE ALL THE OUTPUT VOLTAGE(EXCLUDE +5V STANDBY), AS LOGIC LEVEL IS LOW, OUTPUTS VOLTAGE WERE ENABLE, AS LOGIC LEVEL IS HIGH, OUTPUTS VOLTAGE WERE DISABLE.
‧3.3V/5V REMOTE SENSING
‧COOLING: ONE 40mm DC FAN
‧CONNECTOR POWER INPUT
A. POSITRONIC; PLB06M CONNECTOR
B. TERMINAL BLOCK