Skip to product information
Fortron Source ATX-300PA 300w / 350w / 400w ATX Power Supply
  • Fortron Source ATX-300PA 300w / 350w / 400w ATX Power Supply
  • Fortron Source ATX-300PA 300w / 350w / 400w ATX Power Supply
Fortron Source ATX-300PA 300w / 350w / 400w ATX Power Supply
$62.00 $74.00
Features
 
  • High efficiency over 70%
  • Over-voltage protection
  • Over-current protection
  • Short-circuit protection
  • Approved by UL, CSA, TUV, NEMKO, CB & FCC
  • Internal 8 cm fan
  • MTBF: 100K hours at 25C
Specifications
 
Input Specifications
? Voltage:
 		 110-127/220-240VAC
? Frequency: 47 Hz to 63 Hz
? Input current: 8 amps maximum / 115 Vrms, 60 Hz.,
4.5 amps maximum / 230 Vrms, 50Hz
 
Output Specifications
? Over-voltage protection: +3.3V (4.6V max.), +5V (6.5V max.),
12V1 (15.5V max.), 12V2 (15.5V max.)
? Over-current protection: +3.3V (75.0A max.), +5V (57.0A max.),
12V1 (30.0A max.), 12V2 (30.0A max.)
? Short circuit protection: The power supply is prevented from output over current.
? Remote ON/OFF control: The power supply shall accept a logic open collector level which
will disable / enable all output voltage (excluding +5V standby).
? Power good signal: 115V/230V (full load) 100 - 500 ms
 
General Specifications
? MTBF:
 		 100K hours at 25C
? Efficiency: 70% min.
? Hold-up time: 12.0ms minimum at 115V/60Hz (full load),
16.0ms minimum at 230V/50Hz (full load)
 
Environmental Specifications
? Temperature range:
 		 operating 0C~50C, storage -20C~65C
? Humidity: 90~95% RH
? Dielectric strength: primary to frame ground 1800 VAC for 1 second,
primary to secondary 1800 VAC for 1 second
Output
 
Output Voltage Min. load Max. load Load Reg. Ripple & Noise
+3.3V 0.5A 20.0A 5% 50 mV P-P
+5V 1.0A 20.0A 5% 50 mV P-P
+12V1 1.0A 16.0A 5% 100 mV P-P
+12V2 1.0A 16.0A 5% 100 mV P-P
-12V 0.0A 0.3A 10% 100 mV P-P
-5Vsb 0.0A 2.0A 10% 50 mV P-P

You may also like