HP Pavilion 0950/1956 Replacement PS3 Power Supply w/ Video Connector
HP Pavilion 0950/1956 Replacement PS3 Power Supply w/ Video ConnectorHP Pavilion 0950/1956 Replacement PS3 Power Supply w/ Video Connector
HP Pavilion 0950/1956 Replacement PS3 Power Supply w/ Video Connector
Model: PS-HP-Pavilion-Video
45.99

Specifications
HP Pavilion 0950/1956 Replacement PS3 Power Supply w/ Video Connector

This bigger 200watt Replacement Power Supply is suitable for HP part numbers 0950-2700, 0950-2800, 0950-3426, 0950-3623, 0950-3751, 0950-3961, 0950-4097, 0950-4106, 0950-4107, 0950-4270, 5184-3961, 5185-2974, and Bestec models ATX-1956D, ATX-1956F, ATX-1951D, LiteOn Model# PS-6161-2H,  PS-6161-2H-1, PS-6161-2H1, Delta DPS-200PB-139A

This Replacement power unit has the following connectors:
(1) ATX connector, (1) ATX12V connector, (1) video power connector, (5) peripheral power connectors, and (1) floppy drive connector.

Features:
v High efficiency switching power supply

v Low ripple &Noise

v Output Voltage Protection OVP

v Short circuit protection on all output

v Reset table power shut down

v Approve by UL, CAS TUV, NEMKO, CB & CE

v Internal 8cm fan

v 100% burn-in under high ambient temperature (50ēC) vacuum-impregnated transformer

v MTBF: 100K hours at 25ēC

v 100% Hi-pot tested

v Line input fuse protection

Input Characteristics:
v Voltage: 115/230 VAC

v Frequency: 47Hz to 63Hz

v Input current:
7A max./ 115 Vrms, 50 Hz
4A max/ 230 Vrms, 60Hz

Specifications:
v Remote ON/OFF Control: The Power supply shall accept a logic open collector level which will disable /enable all out put voltage (excluding +5V standby).

v Temperature range: operating 0?~50ēC, storage-20?~ +80ēC

v Temperature coefficient: 0.01% / 0?#60;br>
v Transient response: output voltage recovers in less than 1 ms max. following a 25%load change

v Hold-up time: 17ms minimum at full load & nominal input voltage

v Humidity: 5~95% RH

v Efficiency: 65% min. at full load

v Power good signal: turn-on delay 100ms to 500ms

v Dielectric withstand: input / output 1800VAC for1 second, input to frame ground 1800VAC for 1 second

v Overload protection: 150% max.

v Inrush current: 50A cold, 80A warm at 132VAC

v Over voltage protection:
+5V output: 6.5V max.
+3.3V output: 4.6V max.
+12Vdc output: 15.5V max.

v Fan Noise Killer Standard